INFLUENCE OF NEUTRON IRRADIATION ON THE TEMPERATURE DEPENDENCE OF MAGNETIC SUSCEPTIBILITY IN Fe - Ni INVAR ALLOYS WITH VARYING NICKEL CONTENT
DOI:
https://doi.org/10.59957/jctm.v61.i6.2026.19Keywords:
invar alloys, ferromagnetic, magnetic hysteresis, curie temperature, magnetic susceptibilityAbstract
This study systematically examines the effects of neutron irradiation and alloy composition on the magnetic behavior of Fe - Ni Invar alloys. Three compositions Fe - 22 % Ni, Fe - 30 % Ni (classical Invar composition), and Fe - 50 % Ni were selected to elucidate the interplay between chemical disorder, irradiation-induced modifications, and magnetic properties. The samples were irradiated using a 100keV pulsed neutron source at a dose of 1015 neutrons cm-2. Magnetic characterization was carried out using a vibrating sample magnetometer (VSM) in conjunction with temperature-dependent magnetic susceptibility measurements performed at different orientations between the neutron beam direction and the applied alternating magnetic field. The results demonstrate a pronounced dependence of magnetic behavior on both alloy composition and irradiation conditions. For the Fe - 30 % Ni alloy, the Curie temperature was determined to be approximately 315K. Following neutron irradiation, a significant extension of magnetic ordering was observed, with locally ferromagnetic regions persisting up to approximately 460K. This behavior is attributed to irradiation-induced defects that locally modify the electronic structure, enhance 3d electron localization, and increase effective exchange interactions. The magnetic susceptibility also exhibits a clear angular dependence, indicating anisotropic defect distribution. Complementary structural characterization using X-ray diffraction (XRD) and scanning electron microscopy (SEM) reveals the coexistence of ordered and disordered phases and a heterogeneous microstructure, which correlate strongly with the observed magnetic properties. These findings provide evidence of defect-mediated ferromagnetism and highlight the potential of controlled irradiation for tailoring magnetic properties in Fe - Ni alloys.
References
A. Sahoo, and V. Medicherla, “Fe-Ni Invar alloys: a review,” Materials today: proceedings, 43, 2021, 2242-2244.
G. Kotliar, S. Y. Savrasov, K. Haule, V. S. Oudovenko, O. Parcollet, and C. Marianetti, “Electronic structure calculations with dynamical mean-field theory,” Reviews of Modern Physics, 78, 3, 2006, 865-951.
B. Li, J. Wang, L. Liu, X. Shen, Y. Sun, D. Zhou, Y. Ding, and A. Yan, “Stress relief annealing of super Invar alloy: microstructure, soft magnetic and thermal expansion properties,” Journal of Alloys and Compounds, 1010, 2025, 177975.
L. S. Billgates, V. Rajeevan, and R. J. Joseyphus, “Temperature-dependent magnetic properties of bcc and fcc FeNi alloys: A machine learning assisted Monte-Carlo approach,” Physica B: Condensed Matter, 692, 2024, 416389
D. N. Polsin, D. A. Chin, T. S. Duffy, M. Ginnane, X. Gong, L. E. Hansen, A. J. LaPierre, M. C. Marshall, G. W. Collins, and J. R. Rygg, “Atomic structure and melting of Ni and Fe 36 Ni up to 400 GPa,” Physical Review B, 109, 21, 2024, 214112.
T. Mizoguchi, “Basic magnetic properties of amorphous alloys,” Tohoku University, 1978.
L. Stashkova, N. Mushnikov, V. Gaviko, and A. Protasov, “Calorimetric studies of phase transformations in Fe–Ni alloys,” Physics of Metals and Metallography, 123, 10, 2022, 971-978.
J. Crangle, “The magnetic properties of solids,” (No Title), 1977.
J. Valenzuela, J. Valderruten, G. P. Alcázar, H. Colorado, J. Romero, J. González, J. M. Greneche, and J. Marco, “Low temperature study of mechanically alloyed Fe67. 5Ni32. 5 Invar sample,” Journal of Magnetism and Magnetic Materials, 385, 2015, 83-87.
A. Sahoo, A. A. Biswal, S. Parida, V. Medicherla, S. S. Behera, M. Singh, A. Sagdeo, S. Datta, A. Singh, and K. Maiti, “Electronic, magnetic and thermal behavior near the Invar compositions of Fe-Ni alloys,” Journal of Electron Spectroscopy and Related Phenomena, 2025, 147540.
T. Nagayama, T. Yamamoto, and T. Nakamura, “Thermal expansions and mechanical properties of electrodeposited Fe–Ni alloys in the Invar composition range,” Electrochimica Acta, 205, 2016, 178-187.
Y. Kakehashi, “Finite-temperature theory of local-environment effects in Fe-Ni alloys,” Physical Review B, 38, 1, 1988, 474.
N. Ishikawa, A. Iwase, Y. Chimi, O. Michikami, H. Wakana, and T. Kambara, “Defect production induced by primary ionization in ion-irradiated oxide superconductors,” Journal of the Physical Society of Japan, 69, 11, 2000, 3563-3575.
V. Nadutov, S. Kosintsev, Y. O. Svystunov, V. Garamus, R. Willumeit, H. Eckerlebe, T. Ericsson, and H. Annersten, “Anti-Invar properties and magnetic order in fcc Fe–Ni–C alloy,” Journal of magnetism and magnetic materials, 323, 22, 2011, 2786-2791.
Y. Ghotekar, R. K. Varma, V. Shah, H. Modi, A. Vora, A. Lal, and B. Makwana, "Thermo-chemical characterisation of Fe–Ni alloys for space applications," Advances in material science and metallurgy: select proceedings of ICFAMMT 2022, : Springer, 2023, 15-27.
R. Yang, H. Xie, Y. Sun, W. Huang, Y. Fang, and J. Liu, “Codeposition behavior of Fe-Ni alloys: A review in mechanisms, preparation and effects on composition,” Materials Science and Engineering: B, 310, 2024, 117723.
G. Yang, J. Li, and W. Hua, “Investigation of electromagnetic torque generation mechanism in FSCW V-IPM machines considering magnetic saturation,” IEEE Transactions on Transportation Electrification, 2024.
S. A. Khan, A. B. Ziya, A. Ibrahim, S. Atiq, M. Usman, N. Ahmad, and M. Shakeel, “Enhancement of Curie Temperature (T c) and Magnetization of Fe-Ni Invar alloy Through Cu Substitution and with He+ 2 Ion Irradiation,” Journal of Electronic Materials, 45, 2016, 2258-2265.
M. Khan, G. Serafeim, and A. Yoon, “Corporate sustainability: First evidence on materiality,” The accounting review, 91, 6, 2016, 1697-1724.
H. T. Fujii, S. Matsumura, N. Sakaguchi, H. Ohno, and K. Ona, "Unlocking the potential of non-ferromagnetic invar-type alloys in space exploration." pp. 154-164.
G. Huang, G. He, X. Peng, Y. He, H. Chen, K. Huang, and Y. Liu, “Effect of processing parameters on the microstructure, mechanical properties and thermal expansion behavior of Invar 36 alloy manufactured by laser powder bed
fusion,” Materials Science and Engineering: A, 897, 2024, 146329.
T. Shavishvili, and I. Kiliptari, “Distribution of hyperfine fields and magnetic perturbation in cobalt alloys with 3d transition metals,” physica status solidi (b), 92, 1, 1979, 39-47.
A. Sahoo, V. Medicherla, K. Vijay, and S. Banik, “Resonant photoemission studies on Fe-Ni alloys,” Journal of Alloys and Compounds, 994, 2024, 174544.
J. Deportes, B. Ouladdiaf, and K. Ziebeck, “Thermal dependence of the longitudinal spin fluctuations in YMn2,” Journal de Physique, 48, 6, 1987, 1029-1034.
Downloads
Published
Issue
Section
License
Copyright (c) 2026 Journal of Chemical Technology and Metallurgy
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
